close

The de-icing salt must be evenly distributed. A handful of road salt per square meter is usually sufficient. Be sure to distribute the salt evenly over the entire surface. For large surfaces, it can take you a long time if you do the sanding by hand. You can visit website to learn more.

How Do I Apply De-Icing Salt?

Adding too much salt or salt for snow near me to an icy surface wastes money and increases damage to concrete, metal, drinking water, and vegetation. This requires using defrosters sparingly. The choice of how much to use depends on the deicer. For rock salt, a handful per square meter, approximately for calcium chloride, the quantity will be less, approximately a handful per three square meters. A few precautions are necessary.

1) Shovel the snow as soon as possible and often. If the temperature drops, the snow can become icy and more challenging to remove.

2) The more ice you scrape and remove, the less you need to defrost.

3) After removing snow and ice, sprinkle salt sparingly.

4) As the sun rises and the temperature rises, the defroster will make a mixture of water and ice. Remove it before the temperature drops again, allowing you to have an ice-free surface until the next storm.

When To Add Road Salt

Applying a layer of salt, which reduces the temperature of the water and melts the ice, is the most typical method of clearing icy roadways. Road salting is an effective practice for preventing weather-related collisions.

When Should Road Salt Be Added?

Before the storm, pre-salting the road, sidewalks and driveways prevent ice from sticking to the roadway and reduces the need for salting afterward. This can reduce the use of road salt and is best done two hours before snowfall. Ideal for homeowners and renters is to spread road salt before snowfall or just after the evening freezing peak when temperatures turn below freezing. The quantity to be spread is one kilo of salt for about thirty square meters.

Alternatives to road salt are sand or other mineral grains. If you still wish to water the critical areas, you can choose a de-icing agent containing calcium chloride (wet salt), which you can obtain from the SODEPAC Company, which is less harmful than the usual salt based on sodium chloride. It is more expensive, but smaller quantities are sufficient.

Agents such as gravel, granules, or sand do not melt the ice but settle in the ice layer, thus significantly reducing the risk of slipping. After thawing, these materials can be swept up, disposed of, or reused.

Leave a Response